# Manually Provisioning Cisco ATA

**Category:** Cloud PBX Handsets
**URL:** https://www.simtex.com.au/support/kb/cloud-pbx-handsets/manually-provisioning-cisco-ata
**Published:** 2020-10-20

Cisco devices do not support Zero Touch provisioning hence require some initial manual configuration.

## Cisco Manual Provisioning

**Cisco devices do not support Zero Touch provisioning hence require some initial manual configuration.**

##### Web Interface Access

1. When the ATA has booted you will need to connect an analogue phone to either **PHONE 1** or PHONE2 port on the back of the ATA

2. To get the IP address of the ATA we will need to do the following:

Pick up the handset of the analogue phone and dial ********, If you are prompted for a password enter 24726

3. Next we will dial **110#** and the IVR will read out the IP address of the device to you

- Within your web browser go to the **IP address** found in step 2.2

- Click **Admin Login** on the top right, type in username and password**
Username: admin

Password: admin

![](https://www.simtex.com.au/uploads/login_274d0f875e.png)

- Click Voice** on the top bar

- Click on the **Provisioning** tab on the left hand side

##### SPA112 / SPA121 ATA Series

1. Under **Profile Rule**, enter the following:

```
http://config.mycloudvoip.com.au/$PN_$MA.bin
```

![](https://www.simtex.com.au/uploads/profilerule_corrected_793201ff2c.png)
Click Submit to save changes

2. When the webpage finishes saving, power cycle the ATA (disconnect power and reconnect

3. You’re done!  Now go ahead and test inbound and outbound calls

##### ATA19x Series

1. Under **Profile Rule**, enter the following:

```
http://config.mycloudvoip.com.au/$PN_$MA.xml
```

![](https://www.simtex.com.au/uploads/profilerule_corrected_793201ff2c.png)

2. Click on **Line 1** on the left hand side and then scroll down to the **Subscriber Information **section and enter:**
· Account number in the User ID** field**
· SIP password for that service in the Password** field.**
*The Account number and SIP Password information can be found within the MyCloudVoIP account portal*![](https://www.simtex.com.au/uploads/subscriber_2_4f6184ae8a.png)

3. Click Submit** to save changes

4. When the webpage finishes saving, power cycle the ATA (disconnect power and reconnect

5. You’re done!  Now go ahead and test inbound and outbound calls

**Tags:** apa191, ata, ata192, cisco, spa112, spa121

## Related

- Article: https://www.simtex.com.au/support/kb/cloud-pbx-handsets/manually-provisioning-cisco-ata
- Category: https://www.simtex.com.au/support/kb/cloud-pbx-handsets
- Knowledge Base: https://www.simtex.com.au/support/kb
- Full AI reference: https://www.simtex.com.au/llms-full.txt